Water Softener Installation in Moab, UT

Water Softener Installation in Moab, UT

Water softener installation in Moab, UT starts with a hardness test, because the size of the tank depends on it. Moab, UT Water Softener Installation measures your water in grains per gallon, counts the people in the house, and works out how many grains the system has to pull out each day. From there we pick the resin capacity, usually 32,000, 40,000 or 48,000 grains for a single-family home.

The install itself is careful plumbing. We cut into the main line after the meter or pressure tank, add a three-valve or single-handle bypass, and connect the mineral tank and brine tank on a level spot near a drain. The drain line gets a proper air gap so wastewater can never siphon back. If your outdoor spigots are on the same line, we can loop them out so you aren't softening lawn water.

After the plumbing, we program the control head:

• Hardness setting from your test result
• Regeneration time, usually 2 a.m.
• Salt dose for efficient regeneration

We run a manual regeneration before we leave and test the softened water at a faucet. For water softener installation in Moab, UT, call Moab, UT Water Softener Installation at (833) 995-0133 and get on the schedule.